I would have to have a 2" conduit to pull the plugs through instead of a 3/4" conduit. Disconnecting a device will require unscrewing appropriate terminals in the controller for that device and pulling out cable.Įxtra cable length is not helpful. If any device goes bad the whole "pedestal" (supporting all floats and the pump) will have to be pulled out of the tank and all devices disconnected. If the pump goes bad it has to be replaced. If a float goes bad it has to be replaced. Includes a tough and solid 1/2HP cast-iron sewage pump with a strong, tethered mechanical float switch, a pump performance valve and a water. The system features an injection-molded structural foam polyethylene basin and cover for exceptional, heavy-duty durability. The pump pumps the "wine" into the drainfield at certain fixed times and for a set number of minutes as long as the sewage level is above the lowest float. Arrives pre-plumbed with no internal plumbing needed and ready for installation. The controller is designed to monitor sewage levels (via three float switches in the tanks) and in response to switch on the pump. Also the septic controller has breakers for each circuit, so they can be switched off there. These can be switched off at the main panel. I have two dedicated circuits going to the septic. So, can I just cut off the plugs and be done with them?ĭisconnect is not an issue plugs not helpful While it would be possible to retain the two plugs, it would be very inconvenient because I would have to provide for storing the extra cable length and the conduit would have to be huge to pass the plugs through to covered outdoor outlets wired specially to connect them to controller terminals. I was planning to cut off excess cable length coming out of the ground (including the plugs) and connect all four cables directly to the controller terminals through PVC conduit. In my situation the plugs are not helpful. Guide to septic pump or sewage ejector pump installation: This article describes sewage ejector pumps and residential or light commercial-use sewage grinder pumps used to move wastewater from low areas to a septic tank or to a municipal sewer line. With a simpler septic system there would be no controller and the pump would plug into the switching/pass-through plug which would plug directly into one receptacle. But one float ends in a "switching/pass-through grounded plug". Floats are essentially on-off switches signaling sewage levels in the tanks. The 120 VAC pump comes pre-wired with a grounded plug. One 4/10 or one 1/2 HP UL/CSA listed automatic sewage pump. Each sewage basin package includes: One 24' x 30' polyethylene basin with 4' external inlet hub. Four cables for these devices exit from the underground tanks. These pre-assembled sewage basin packages are completely ASSEMBLED and ready for installation. Devices connected to the controller include one 120 VAC pump and three floats. Rising wastewater should lift the float that in turn operates a switch that turns on the pump. Everything is connected to the septic controller which has its own breakers for two circuits. If your sewage grinder pump or sump pump is not turning on and off correctly, check the holding tank for clogging debris and check the operation of the sewage pump float control switch. From another post I just saw this: "Cutting the plugs off would violate the UL listing."
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |